:: Gauges & Fixtures::
Measuring Pins
Measuring Pins are hardened to 60-63 HRC Length 40 mm for range 
below 3mm & Length 50 mm for range above 3 mm.
Lapped to Impart high surface finish
Mfg Tolerance + 0.002 mm on diameter Carefully packed in Plastic Cases.
Measuring Pin Boxes Packed in Wooden Case & Rust Preventive Powder Applied on it.
With Wide range in step of 0.1 ,0.02, 0.05,0.01, 0.005 asper customer requirement.
For Sizes More Than 200 mm Size Use Our Uniquely designed ID/ OD Checking Comparator Type Gauge.
Plain Plug Gauges
Reversible Type Plug Gauge
Sizes 1- 6 mm
Fixed Type Plug Gauge
6 mm - 160mm
Note : 1-6 are fixed in Aluminium Handles
6-40 Taper Lock Design (IS: 6137: 1983)
40-100 Disc Type TYpe Design (IS: 6244 :1980)
100-250 Plate Type Design
Fixed Snap Gauges
1 - 250 mm
Single Ended ( C Type ) or Double Ended ( H Type)
Master Ring Gauges
Sizes : 3 - to 200 mm
For Sizes More Than 200 mm Size Use Our Uniquely designed ID/ OD Checking Comparator Type Gauge.
Material Used for All Above Gauges will be OHNS ( Tungston Based) or En31.
All Will be Provided with NPL Traceable Calibration Certificates , NABL on Request.
Air Gauge Units & Air Gauges
Special Gauging
Their are some critical parameters in the modern products which are not possible to inspect with standard gauges. For that one has to use special gauging. These are inspection Fixtures designed exclusively as per certain customer specific requirement. These can be with the use of Electronic or Dial Comparators so that exact errors can be detected.
So for any non standard requirement we can help customers , as we have expertise who can help you to reduce you inspection problems.
